The RB-SM1 converts a stereo input to a fully buffered and balanced mono line output, e.g. to supply cue in broadcast environments or to feed a mono PA system.
The connections, which are on the rear panel, are of an XLR-3 type. The input is electronically balanced with an impedance of 20kΩ bridging. This can be wired unbalanced to accept an output from domestic equipment.
The output is electronically balanced with an output impedance of <50Ω. The output can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.
Output gain adjustment using a pre-set potentiometer for the converter allows a normalised mono output from domestic stereo equipment. This potentiometer is accessible through the rear panel.
Technical Specification For RB-SM1
|Maximum Input Level:||+28dBu|
|Maximum Output Level:||+28dBu|
|Input Impedance:||>20kΩ balanced bridging|
|Output Impedance:||<50Ω balanced|
|Frequency Response:||20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)|
|Gain Range:||Adjust -8dB to +18dB gain, ref. 0dB input on L and R|
|Common Mode Rejection:||>66dB typically|
|Distortion:||0.01% THD @ 1kHz, ref +8dBu output|
|Noise:||-100dB, unity gain, ref +8dBu output|
|Inputs:||2 x XLR 3 pin female (Balanced, can be unbalanced)|
|Outputs:||1 x XLR 3 pin male (Balanced, can be unbalanced)|
|Mains Input:||Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max|
|Fuse Rating:||Anti-surge fuse 100mA 20 x 5mm (230VAC)
Anti-surge fuse 250mA 20 x 5mm (115VAC)
|RB-SM1:||Single stereo to mono converter|
|Dimensions (Raw):||28cm (W) x 10.8cm (D) x 4.2cm (H) (1U)
11” (W) x 4.3” (D) x 1.7” (H) (1U)
|Dimensions (Boxed):||36cm (W) x 20.5cm (D) x 6cm (H)
14.2” (W) x 8” (D) x 2.4” (H)
|Weight:||Nett: 1.00kg Gross: 1.45kg
Nett: 2.2lbs Gross: 3.2lbs
This product has not yet been rated, be the first to write a review!